Cisco Aironet 340 Series Hardware Installation Manual page 31

Chapter 2 Installation
Connect the other end of the Ethernet cable to the device that will supply power.
Step 3
If you use a power injector, follow these additional steps:
Plug the cable from the access point into the end of the power injector labeled To AP/Bridge.
a.
Run an Ethernet cable from the end of the power injector labeled To Network to the 10/100 Ethernet
b.
switch.
Plug the female end of the power cord into the universal power supply.
c.
Plug the male end of the power cord into a power outlet or power strip.
d.
At start-up, all three LEDs on the top of the access point slowly blink amber, red, and green in sequence;
the sequence takes a few minutes to complete. During normal operation, the LEDs blink green. Refer to
Chapter 4, "Troubleshooting,"
Follow the steps in
Step 4
OL-0738-02
for LED descriptions.
Chapter 3, "Basic Configuration,"
Connecting the Ethernet and Power Cables
to assign basic settings to the access point.
Cisco Aironet Access Point Hardware Installation Guide
2-9