Verifying And Configuring The Backup Software Solution; Resetting The Boot Retry Counter - Fujitsu PRIMERGY RX100 S8 Upgrade And Maintenance Manual

Basic software procedures
5.2.5 Verifying and configuring the backup software
solution
I
This task only applies to the Japanese market.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
This is the case for the following backup software solutions:
– Netvault for Windows
– ARCServe
– BackupExec
I
Procedures may differ depending on the backup software. For details,
refer to the dedicated documentation provided separately.
Further information on suitable backup software solutions and related
documentation is available to Fujitsu service partners from the Fujitsu
Extranet pages.
Re-enabling backup drives
If a backup drive has been disabled or deleted from the backup software drive
list as described in section
the maintenance task.
Ê Re-enable backup drives and revise backup software settings and cronjobs.
I
Detailed information on suitable backup software solutions and
related documentation is available to Fujitsu service partners from the
Fujitsu Extranet pages
5.2.6

Resetting the boot retry counter

The boot retry counter is decremented from its preset value every time the
POST watchdog initiates a system reboot. When the value has reached '0', the
system will shut down and power off.
76
5.1.4 on page
Upgrade and Maintenance Manual
66, it has to be re-enabled to complete
RX100 S8