Installing The New Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX100 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card as described in section
on page 164.
9.4.3.3

Installing the new expansion card

Ê If applicable, install the slot bracket as described in section
bracket" on page
Ê Install the expansion card as described in section
card" on page
9.4.3.4

Concluding steps

Ê Install the corresponding riser module as described in section
riser modules" on page
"Reassembling" on page 52
Ê
"Connecting the server to the mains" on page 55
Ê
"Enabling replaced components in the system BIOS" on page 79
Ê
"Updating RAID controller firmware" on page 74
Ê
"Enabling SVOM boot watchdog functionality" on page 78
Ê
"Switching on the server" on page 57
Ê
"Enabling BitLocker functionality" on page 84
Ê
Ê After replacing a network controller in a server running Linux OS,
the NIC configuration file in a Linux environment" on page
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section
network settings recovery" on page
Ê If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking up changed MAC / WWN addresses" on page
176
159.
172.
58.
Upgrade and Maintenance Manual
"Removing a slot bracket"
"Installing the expansion
175.
88.
"Installing a slot
"Handling
"Updating
83.
"Note on
"After replacing /
85.
RX100 S8