D-Link SecuriCam DCS-2100+ Manual page 10

Software Installation (continued)
Click IP Installer
The opening IP Installer screen will appear
and show a MAC address of the DCS-
2100+ and an IP Address (which may or
may not be correct depending on what
you have your DCS-2100+ connected to).
If you have a DHCP* server on your
network, there will be a valid IP Address
displayed here, indicated by a "Yes" under
the assigned column.
*A DHCP server is a device that supplies
IP Addresses to its clients that are on
the same network.
IMPORTANT:
A hardware reset of the Internet Camera may be required if the IP Installer
cannot find the camera. To accomplish this reset, lightly insert a paper clip (or a
similar sized tool) into the reset hole on the back of the camera (see page 6 for
the location of the reset button.) The LED on the front of the camera will begin
blinking red and green. When it stops the blinking cycle continue to hold in the
reset button until a second cycle of blinking red and green lights indicates a
second reset cycle has completed. This will take approximately 5-7 seconds.
10