Removing Accessible Drive Dummy Covers; Installing The Multibay Box - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Accessible drives and LSD
Figure 223: Installing the 3.5-inch installation frame in the Multibay box (B)
Ê Secure the installation frame in the Multibay box with two screws (M3 x 6
mm) on either side.
Ê Before inserting the Multibay box into the chassis, connect the LSD cable to
the LSD module.

12.5.1.4 Removing accessible drive dummy covers

Ê If applicable, remove the accessible dummy covers for installation bay 1 as
described in section
page 180.

12.5.1.5 Installing the Multibay box

Ê Ensure that the four mounting brackets in installation bay 1 have not been
bent out (see figure 212).
Ê Press out on the locking latch to disengage the accessible drive locking bar
(see figure 213).
Ê Fold up the accessible drive locking bar.
308
"Removing accessible drive dummy covers" on
Upgrade and Maintenance Manual
TX2540 M1