Installing The New Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
page 220.
9.4.3.3

Installing the new expansion card

Ê If applicable, install a slot bracket on the new expansion card as described
in section "Installing a slot bracket" on page
Ê Install the expansion card as described in section
cards" on page
9.4.3.4

Concluding steps

"Reassembling" on page 62
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the mains" on page 72
Ê
"Enabling replaced components in the system BIOS" on page 93
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 100.
"Updating the NIC configuration file in a Linux environment" on page 97
Ê
"Updating RAID controller firmware" on page 88
Ê
"Enabling SVOM boot watchdog functionality" on page 93
Ê
"Switching on the server" on page 73
Ê
"Enabling BitLocker functionality" on page 98
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable,"After replacing / upgrading LAN controllers" on page
236
227.
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
"Removing a slot bracket" on
216.
"Installing expansion
235.
"Note on network
103.
TX2540 M1