Status Information; Power On And Shut Down; Power On - NETGEAR ReadyNAS 102 Hardware Manual

Status Information

You can obtain information about the status of your storage system by reviewing the
indicators listed in the following table.
Table 6. ReadyNAS 516 indicator descriptions
Indicator
Disk LEDs
Rear panel Ethernet port
LEDs
Status display screen

Power On and Shut Down

This section describes how to power on and shut down your system. If you need to shut
down the system, use one of the preferred shutdown methods whenever possible.

Power On

When the system is connected to a power supply and the Power switch is in the On position,
the system automatically powers on.
You can also power on the system by pressing the Power button on the front panel of the
system.
ReadyNAS OS 6 Desktop Storage Systems
Description
A disk LED next to each drive bay indicates the status of the disk inside. The disk
LEDs have these states:
• Solid blue. Power is on and the disk is operating normally.
• Blinking blue. The disk is active.
• Solid red. The disk was removed, failed, or is resynchronizing. See the
display screen for details.
• Off. No disk is present.
Two LED status indicators are built into this port, one green and one amber. They
indicate port speed and activity as follows:
• Green on, amber off. 1000 Mbps connection speed, no activity.
• Green blinking, amber off. 1000 Mbps connection speed, activity.
• Green off, amber on. 10 Mbps or 100 Mbps connection speed, no activity.
• Green off, amber blinking. 10 Mbps or 100 Mbps connection speed, activity.
• Green off, amber off. No connection.
Displays messages about the status of your storage system. Note that the status
display screen goes to sleep to prevent burn-in. To wake the status display screen,
activate the proximity sensor, press the touchpad, press the OK button, or press
the Power button once. If the storage system reports an abnormal operation or
error, the status display screen stays on.
NETGEAR ReadyNAS 516
53