Table of Contents
Advertisement
Forced Shutdown
Perform a forced shutdown only if the storage system is not responding.
To perform a forced shutdown:
Unplug the system from the power supply.
Power State
If the power supply is interrupted due to a power failure, the system returns to its last state
once the power supply is restored:
•
If the system was powered on at the time of the power failure, the system powers on
when the power supply is restored.
•
If the system was powered off at the time of the power failure, the system remains off
when the power supply is restored.
Boot Menu
Use the boot menu to restart or troubleshoot your ReadyNAS storage system. Your storage
system has the following boot modes:
•
Normal. Initiates a normal boot process, just like booting using the Power button.
•
Factory default. Initiates a short disk test that takes approximately 5 minutes. After the
disk test, a 10-minute time-out period begins.
WARNING:
The factory default reboot process resets the storage system to
factory settings, erases all data, resets all defaults, and reformats
the disk to X-RAID2.
-
If you want to cancel the factory default process, power off the storage system before
the 10-minute time-out ends. The system powers down safely without causing any
data loss.
-
If you want to reset the system to factory default settings, do not power off your
system. After the 10-minute time-out period, the factory default process begins.
Tip:
To start the factory default process immediately, press the Backup
button during the 10-minute time-out period.
•
OS reinstall. Reinstalls the firmware from the internal flash to the disks. Use the OS
reinstall boot mode when the system crashes and corrupts some configuration files. OS
reinstall boot mode also resets some settings on your storage system, such as Internet
protocol settings and the administrator password, to defaults.
ReadyNAS OS 6 Desktop Storage Systems
NETGEAR ReadyNAS 104
23
Hide quick links:
Advertisement
Table of Contents
