Data Entry - Honeywell BENDIX/KING KLN 94 Pilot's Manual

Chapter 3 Basic GPS Operation
last viewed—we'll say the NAV 2 page. Turning the right inner knob one
click clockwise or three clicks counterclockwise will bring you to the NAV 3
page. Or, from the APT 2 page you could turn the right outer knob four
clicks counter-clockwise to get to the NAV pages. Got it?
NOTE: In this Pilot's Guide the right smaller knob is assumed to be in the
"in" position unless it specifically states that the knob should be in the "out"
position. Therefore, the words "rotate the right inner knob" mean to turn
the right inner knob while the knob is in the "in" position.

3.4.2. DATA ENTRY

Now that you've learned how to select the desired page, you're ready to
learn the means of entering data. It is necessary to enter data, for exam-
ple, in order to specify a waypoint of your choice to go Direct To. The
general procedure for entering a waypoint identifier is described below
and is shown in figures 3-35 through 3-43 for entering a waypoint (in this
case, First Flight airport in North Carolina, identifier KFFA) on the Auxiliary
4 (AUX 4) page.
To enter a waypoint identifier:
1. If the cursor is not on the screen
(figure 3-35), press B to turn
on the cursor function (figure 3-
36).
2. If required, rotate the right outer
knob to position the cursor (fig-
ure 3-37).
3. Rotate the right inner knob to
select the first character of the
waypoint identifier (figure 3-38).
Figure 3-35
Figure 3-36
Figure 3-37
Figure 3-38
3-14