Honeywell HD-DVR-1004 User Manual page 150

Web Client Operation
136
Parameter Function
There are three types: Motion detection/video loss/Camera
Event Type
Masking.
Select channel name from the dropdown list, and check the
Channel
checkbox beside it to enable its motion detection function.
There are six levels.
Sensitivity
sensitivity.
There are six levels.
sensitivity.
Region: If you select motion detection type, you can click this
button to set motion detection zone. The interface is shown in
Region
Figure 6-40
Right-click and you can go to the full-screen display mode. Do
remember to click OK to save your motion detection zone
setup.
Motion detection function becomes activated in the specified
periods.
There are six periods in one day. Please check the checkbox
to enable corresponding period.
Period
Select date. If you do not, the current setup applies to today
only. You can select all week column to apply to the whole
week.
Click OK, and the system goes back to motion detection
interface; please click Save to exit.
Anti-dither Not Effective in the current DVR version.
There is 3-channel alarm output.
Corresponding to motion detection alarm output port (multiple
choices)
Alarm out
Enable alarm activation function. You need to select alarm
output port so that the system can activate the corresponding
alarm device when an alarm occurs.
System can delay the alarm output for a specified time after a
Alarm latch
detection event ends. The value ranges from 10s to 300s.
System auto activates motion detection channel (multiple
choices) to record once alarm occurs (working with motion
detection function). Please note you need to go to the chapter
Record
Motion Detection
channel
to the chapter
auto record.
System can delay the record for specified time after a
Record latch
detection event ended. The value ranges from 10s to 300s.
Email
If you enabled this function, the system can send out email to
The sixth level has the highest
The sixth level has the highest
. There are PAL 22X18/NTSC 22X15 zones.
to set motion detection record period and go
Manual Record
to set the current period as