Table of Contents
Advertisement
• Mouse :
If you plan to use a mouse to control you multiplexer, set
this to On.
• Key lock :
When On, pressing any key or clicking the mouse will
open a screen asking for a password.
• Factory Reset :
A confirmation screen will ask you if you really want to reset
everything.
• Cam No. Offset :
camera numbers based on the Unit Address. Unit 001 will have
Cameras 01 to 9, Unit 002 will have Cameras 10 to 18, etc. When
set to Off, the cameras will be numbered 01 to 9.
• Mouse setup :
change the values as follows.
The ranges which can be changed are Min=minimum, -009~009 and
Max=maximum.
• Master/Slave :
determine if the unit is a master or slave unit.
• Network Type :
RS-485 when connected to a network.
• Baud Rate :
When connected to a network, the baud rate can be set
to 1200, 2400, 4800, 9600 or 19200.
• Unit Address :
from 001 to 255.
• Protocol :
A is multiplexer protocol.
B1 is dome camera control protocol.
• Exit :
Saves your changes and returns to the Main Menu.
Returns all settings to the factory default.
When set to On, the multiplexer will adjust the
If the mouse cannot be worked properly, the user can
When installed as part of a network, this will
The
multiplexer
can be set to RS-232, RS-422 or
Networked multiplexers can be assigned addresses
49
Advertisement
Table of Contents
