Honda H5013 Owner's Manual page 84

n
Battery cleaning
If the battery terminals are contaminated or corroded, remove the battery
and clean the terminals.
1. Remove battery set plate.
2. Disconnect the battery cable at the battery negative (-1 terminal, then
at the battery positive (+) terminal.
6
mm
NUTS
BATTERY SET
) TERMINAL
3. Remove the battery and clean the battery termin,als and battery cable
terminals with a wire brush or sand paper.
Clean the battery with a solution of baking soda and warm water, tak-
ing care not to get the solution or water in the battery cells. Dry the bat-
tery thoroughly.
4. Connect the battery positive (+I cable to the battery positive (+I ter-
minal, then the battery negative f-1 cable to the battery negative (-1
terminal. Tighten the bolts and nuts securely.
NOTE: Install the battery to the rear right part of the battery tray, as
shown in the figure below.
BAlTERY TRAY
FRONT
+
82
BATiERY