Fujitsu DL7600 User Manual page 78

PAPER HANDLING
3-20
Preparing to load a sheet of paper
Loading a sheet of paper
6. Insert a sheet of paper into the paper table. Make sure that the
front edge of the paper engages snugly with the feed roller.
NOTE
If paper skews when it is loaded, the printer does not print and ejects
the paper. (This function can be disabled by a setting in setup mode.)
7. Press the LOAD button. The paper will advance to the top-of-
form position. The top-of-form position is the first line on which
printing can start. To adjust the position of the paper slightly,
press the MICRO FEED button or the
button. The paper will move forward or backward in 1/180-inch
increments.
After loading paper, the printer goes into online mode.
8. Print a sample page and check the page margins. Make the
following adjustments, as necessary:
•
Horizontal alignment. Readjust the paper guide if required.
•
Top-of-form setting (see Chapter 5).
•
Margin settings. Use your software or the printer setup
mode (see Chapter 5).
NOTE
Do not open the front cover during printing. With the cover open
detection option installed, the printer never prints while the front
cover is open. Close the front cover to perform printing.
MICRO FEED
User's Manual