Fujitsu DL7600 User Manual page 54

SETTING UP
2-24
If you are using more than one software package, determine
which emulation is supported by the software you use most
frequently.
Select that emulation.
If your software supports more than one emulation, select the
DPL24C PLUS emulation if possible. This emulation has the
greatest capabilities.
If you want to use an emulation that is not supported by your
software, contact your software manufacturer or printer dealer
and ask whether support is available. You may be able to obtain
a printer driver that is not shipped with the original software
package.
To select an emulation, proceed as follows(LED):
1. Turn the printer on and load continues forms.
To print the "OFFLINE SET UP MODE", load continuous form
wider than 254 mm (10 inches) and set the left tractor so that the
left end of continuous form may suit "0-10mm" of a scale (see
Chapter 3).
2. Enter setup mode.(LED)
Press the ONLINE button to place the printer offline. Then,
press the setup buttons (AUTO GAP and HI IMPACT).
As the printer enters offline setup mode, it prints the following
information:
NOTE
If LCD type control panel. Please refer to Chapter 5.
OFF
User's Manual