Fujitsu DL7600 User Manual page 150

USING SETUP MODE
5-56
1. Move to TOP MENU of SETUP MODE.(LCD)
Press the " " button until "SETUPMODE" is displayed on LCD
panel.
2. Select the SELF-TST function.(LCD)
Repeatedly press the " " or " " button to display
"SELFDIAGNOSTIC". And then press the" " button to move
lower layer. And then repeatedly press the " " or " " button
to display "SELF-TEST". And then press the "SELECT" button
to start self-test printing. A short help menu is printed at the top
of the page, followed by the self-test. Note that the printer is not
online during self-test printing.
3. Examine the self-test page.
A sample self-test page is shown in Chapter 2. To pause during
self-test printing, press the "LOAD" button. To resume self-test
printing, press the "LOAD" button again.
4. Exit the SELF-TST function.
Exit the SELF-TST function in either of the following ways:
•
To exit SELF-TST and remain in setup mode, press the
LF/FF button. The <<FUNCTION>> menu is then
reprinted (LED type).
•
To exit SELF-TST and return online, press the ONLINE
button. The printer permanently saves any changes made
while in setup mode and returns online.
The self-test can also be started by turning off the printer, and then
pressing the LF/FF button while turning the printer back on. As
described in Chapter 2, this method is useful when you first set up the
printer.
User's Manual