Pump Casing Cleaning - Honda and WT40X Owner's Manual

I
SERVICING YOUR HONDA PUMP
PUMP CASING CLEANING
After each use, clean the inside of the pump casing using the following
procedure:
Removal:
1. Remove the drain plugs from the pump casing and pump cover to
drain the water inside.
2. Loosen the pump cover knobs and open the pump cover holders.
3. Remove the pump cover and the volute case from the pump casing,
and remove any debris from pump casing and volute case;
Installation:
1. Install the O-rings on the pump cover, taking care not to damage the
O-rings.
2. Install the pump cover on the pump casing, close the cover holders,
and tighten the knobs hand tight. Then, insert a screwdriver shaft in
the groove in the knobs and finish tightening the knobs.
3. Install the two drain plugs in the pump cover and pump casing.
4.After tightening the pump cover knobs, check the pump cover and
pump casing to ensure that there is no water leakage.
PUMP COVER KNOB
SCREWDRIVER
VER HOLDER
CkE DRAIN PLUG PUMP COVER
COVER DkAlN PLUG
40