Setting The Oven Controls - Kenmore 318205341A Use & Care Manual

Setting the Oven Controls

Setting the Clock
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
time in the display will flash (See Fig. 1).
To set the clock (example below for 1:30)
1. Press . "CLO" will appear in the display (Fig. 2).
1 3 0
2. Press pads to set the time of day to 1:30 (Fig. 3). Press
"CLO" will disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display
1. Press and hold for 7 seconds until "12Hr dAy" or "24Hr dAy"
appears in the display.
2. Press to switch between the 12 and 24 hour time of day
display. 12Hr dAy (Fig. 5) or 24Hr dAy (Fig. 6) will be displayed.
3. Press to accept the change or press
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
Setting Silent Control Operation
The and pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever
necessary. If desired the control can be programmed for silent operation and later returned
to operating with all the normal sounds and beeps.
To change control from normal sound operation to silent control
operation
1. To tell if your range is set for normal or silent operation press and
hold for 7 seconds (Fig. 7).
2. Press to switch between normal sound operation and silent
operation mode. The display will show either bEEp On (Fig. 8) or
bEEp OFF (Fig. 9).
If bEEp On appears (Fig. 8), the control will operate with normal
sounds and beeps. If bEEp OFF appears (Fig. 9), the control is in
the silent operation mode.
3. Press to accept the change or press
change.
INSTRUCTIONS
INSTRUCTIONS
.
to reject the
to reject the
8
PRESS
1 3 0
for 7 seconds
or
PRESS
for 7 seconds
or
Fig. 1
DISPLAY
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
DISPLAY
Fig. 7
Fig. 8
Fig. 9