Cisco Catalyst 3750-X Command Reference Manual page 820

show power inline
Gi1/0/5
Gi1/0/6
Gi1/0/7
Gi1/0/8
Gi1/0/9
Gi1/0/10
Gi1/0/11
Gi1/0/12
Gi1/0/13
<output truncated>
In the previous example:
• The Gi1/0/1 port is shut down, and policing is not configured.
• The Gi1/0/2 port is shut down, but policing is enabled with a policing action to generate a syslog
message.
The Gi1/0/3 port is shut down, but policing is enabled with a policing action is to shut down the port.
•
• Device detection is disabled on the Gi1/0/4 port, power is not applied to the port, and policing is
disabled.
Device detection is disabled on the Gi1/0/5 port, and power is not applied to the port, but policing
•
is enabled with a policing action to generate a syslog message.
Device detection is disabled on the Gi1/0/6 port, and power is not applied to the port, but policing
•
is enabled with a policing action to shut down the port.
The Gi1/0/7 port is up, and policing is disabled, but the switch does not apply power to the connected
•
device.
The Gi1/0/8 port is up, and policing is enabled with a policing action to generate a syslog message,
•
but the switch does not apply power to the powered device.
The Gi1/0/9 port is up and connected to a powered device, and policing is disabled.
•
The Gi1/0/10 port is up and connected to a powered device, and policing is enabled with a policing
•
action to generate a syslog message. The policing action does not take effect because the real-time
power consumption is less than the cutoff value.
The Gi1/0/11 port is up and connected to a powered device, and policing is enabled with a policing
•
action to generate a syslog message.
• The Gi1/0/12 port is up and connected to a powered device, and policing is enabled with a policing
action to shut down the port. The policing action does not take effect because the real-time power
consumption is less than the cutoff value.
The Gi1/0/13 port is up and connected to a powered device, and policing is enabled with a policing
•
action to shut down the port.
This is an example of output from the show power inline police interface-id command on a standalone
switch.
Switch> show power inline police gigabitethernet0/4
Interface Admin
--------- ------ ---------- ---------- ---------- ------ -----
Gi0/4
Table 2-47
Field
Available
Catalyst 3750-X and 3560-X Switch Command Reference
2-788
off off log
off off errdisable n/a
auto off none
auto off log
auto on none
auto on log
auto on log
auto on errdisable ok
auto errdisable errdisable n/a
Table 2-47 describes the output fields.
Oper Admin
State State Police
auto power-deny log
show power inline police Field Descriptions
Description
The total amount of configured power
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
n/a 5.4 0.0
5.4 0.0
n/a n/a 0.0
n/a 5.4 0.0
n/a n/a 5.1
ok 5.4 4.2
log 5.4 5.9
5.4 4.2
5.4 0.0
Oper Cutoff Oper
Police Power Power
n/a 4.0 0.0
1
on the switch in watts (W).
OL-29704-01