AEG ECLIPSE 10 User Manual page 29

"The Caller Display feature isn't working"
You need to subscribe to the Caller Line Identification service from your network service provider.
The caller may have withheld their number .Or they may be calling from a network that does not transmit
the caller's number (e.g. if they are making international calls.)
"When I try to make a call, I hear busy tone"
If you're using a multi-handset system, check whether another handset is already on a call.
"The volume in the earpiece is low when I'm on a call"
Make sure you're holding the earpiece correctly over your ear.
Adjust the volume using
"I cannot store a phonebook entry"
The maximum number of 200 phonebook entries on your Handset You must delete existing entries to
make space for new ones.
15.3 Intercom and transfer
"I can't transfer a call"
Make sure that the other handset is in range of the base unit.
Make sure that you have entered the correct number for the other handset.
15.4 Batteries
"The handset's battery cells are running low within an hour or two"
Before you first use the handset, you must leave it to charge on the base unit or charging pod for at least
15 hours.
You may need to replace the batteries.
Check the connection between the base unit and the mains power socket.
"I try to recharge the batteries but I still get a warning that they are low"
You need to replace the batteries. Dispose of used batteries safely – do not burn, immerse them in water,
disassemble, or puncture the batteries.
Do not use non-rechargeable batteries in your handset – they may explode, causing damage.
15.5 Registration
"I am not able to register another handset"
The maximum number of 4 handsets has been reached. You will need to unregister a handset in order
to register a new one.
15.6 Answering Machine
"The Answering machine does not record messages"
Make sure that the answering machine is switched on.
Make sure that the Answer Mode is set to RECORD MSGS.
The memory may be full. If so, you will need to delete some messages.
"I cannot access my answering machine remotely"
Make sure that Remote Access is activated.
Make sure that you have entered the correct Remote Access PIN (same as your Master PIN).