Trace (User Type 3.6); Timer Control (User Type 3.6) - Honeywell Galaxy 3-144 User Manual

Trace (User Type 3.6)

PIN + ent
44 = TRACE
[ent] to Select
01:04 Sun 01 Jan
1064 Intruder
09:30 Sun 01 Jan
UNSET MGR

Timer Control (User Type 3.6)

PIN + ent
45 = TIMER CONTROL
[ent] to Select
[ent] to Select
1=View
[ent] to Select
1=TIMER A
A MON ON 19:30
TUE OFF 07:30
PIN + ent
45 = TIMER CONTROL
[ent] to Select
[ent] to Select
2=Holidays
[ent] to Select
1=Modify Dates
01:START >DD/MM
01: END DD/MM
This option provides a record of the most recent alarm activation. The
Trace option records the details of the setting and unsetting of the sys-
tem immediately before and after the alarm activation and the first 5
events occurring during the alarm activation. This information is main-
tained in the trace until the next alarm activation. On entering the op-
tion pressing the A and B keys steps through each of the 7 trace entries.
Pressing the # key while viewing the Trace option displays additional
information about certain events — user events reveal the keypad, user
level and current group; alarm events reveal the zone descriptor if pro-
grammed.
The currentt display trace can be printed out by pressing the
pressing the esc key aborts the print-out.
1=View
This function allows the programmed times in each of the timers to be
viewed and switched on and off as required. Use the A and B keys to
scroll through each of the programmed times.
NOTE:
2=Holidays
This function allows up to 10 holiday periods to be allocated. A Start
and End date is entered for each holiday period using the 1=Modify
Dates option. On selecting this option, the Start and End dates for
holiday period 01are displayed. If no dates have been entered for this
period, then the display will show **/**. To program the Start date,
press the ent key; the date display changes to >DD/MM< ; enter a valid
4 digit number and press the ent key to accept the selection. The year is
not required, only the day and month.
Press the # key to move to the End date and follow the procedure for
programming the Start date.
To remove a programmed date, press the * key. The date display re-
turns to **/**.
NOTE:
The programmed times cannot be modified
using this option.
The holiday periods can only be pro-
grammed by managers and engineers
26
key;