Table of Contents
Advertisement
1. Limit mark
1. Chip cover
2. Screwdriver
1
2
1. Brush holder cap
2. Screwdriver
Immerse the dressing stone in water for 2 or 3 minutes before sharpening.
002592
Hold the holder so that the both blades contact the dressing stone for simulta-
neous sharpening at the same angle.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the chip cover.
002595
1
2
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
002596
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
9
Advertisement
Table of Contents
