Functional Description - Makita 4112HS Instruction Manual

FUNCTIONAL
DESCRIPTION
1
3
2
1. Wing bolt
2. Base
3. Cutting depth
2
1. Clamping nut
2. Wheel guard
A
1
B
2
1. Switch trigger
2. Lock lever
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Adjusting the depth of cut
004013
Loosen the wing bolt on the depth guide and move the base up or down. At the
desired depth of cut, secure the base by tightening the wing bolt.
Securing wheel guard
004014
1
CAUTION:
• The wheel guard must be adjusted on the tool so that the closed side of
the guard always points toward the operator.
The wheel guard can be adjusted about 80 degrees, after you loosen the
clamping nut. Adjust to the desired angle, then secure the clamping nut.
Switch action
004015
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
For tool with the lock-on switch
To start the tool, simply pull the switch trigger (A direction). Release the switch
trigger to stop.
For continuous operation, pull the switch trigger (A direction) and then push in
the lock lever (B direction).
To stop the tool from the locked position, pull the switch trigger (A direction)
fully, then release it.
For tool with the lock-off switch
To prevent the switch trigger from accidentally pulled, a lock lever is provided.
To start the tool, push in the lock lever (B direction) and then pull the switch
trigger. (Adirection)Release the switch trigger to stop.
5