Honeywell HWB1033S Owner's Manual page 9

Free standing water cooler
Hide thumbs Also See for HWB1033S:
Table of Contents

Advertisement

7. INSTALLING YOUR WATER COOLER FOR THE FIRST TIME
1. Ensure the unit is unplugged.
2. Fill water reservoir with tap water full to capacity.
Allow the water to settle into the hot and cold water
tanks for 5 minutes. (Fig. 1)
3. Push each water lever (hot and cold temperature) to
ensure water is running through the unit. (Fig. 2)
4. Plug the dispenser unit into the electrical outlet. Please
review the IMPORTANT SAFETY INSTRUCTIONS and
INSTALLATION GUIDELINES before doing so.
5. Turn ON the hot water switch, wait a couple of minutes
and turn ON the cold water switch. Allow the unit to
reach the minimum cold and hot water temperatures.
This will take approximately 45 minutes and the
indicator lights will turn OFF. (Fig. 3)
6. Test the water temperatures by pushing once again on
the water levers.
7. Turn OFF both hot and cold water switches and unplug
the unit from the electrical outlet.
8. Proceed to drain the water from the faucets one at
a time by pushing on the hot and cold levers until no
more water remains.
9. Turn counterclockwise to open the drain cap and
drain the water from the tanks. Do not tilt the unit to
drain the water. (Fig. 4)
10. Close the drain cap by turning it clockwise.
11. Installing the floor Bracket Kit (Fig. 5)
Note: All hardware is included. Set up requires a drill and a Phillips
screwdriver (not included).
1. Place the L-shaped bracket (2) on the lower left side of the back of
the unit using a Phillip screwdriver to secure the small screw (3).
2. Drill a hole in the floor 6 inches away from the wall. Choose the
appropriate drill bit depending on your floor type (tile, concrete or
wood). Use the size 3/8" diameter to drill a hole 2 inches deep.
3. Place the anchor (1) in the hole so that it is flush with the floor level.
4. Align the L-shaped bracket (2) to the anchor and use the washer (4)
and the long screw (5) to secure the unit to the floor.
12. Your unit is ready to be used. Please proceed with the
water bottle loading instructions.
5 MIN
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents