Installation Instructions Step 2, Install Junction Box - GE Monogram ZET1058 Installation Instructions Manual

Installation Preparation
WARNING
ELECTRICAL SHOCK HAZARD
The electrical power to the oven
branch circuit must be shut-off
while line connections are being
made.
• Use copper wiring only.
• Electrical ground is required on this appliance. The
free end of the green wire (the ground wire) must be
connected to a suitable ground. This wire must
remain grounded to the oven.
• If a cold water pipe is interrupted by plastic, non-
metallic gaskets, union connections or other insulat-
ing materials, DO NOT use for grounding.
• DO NOT ground to a gas pipe.
• DO NOT have a fuse in the NEUTRAL or GROUNDING
circuit. A fuse in the NEUTRAL or GROUNDING circuit
could result in an electrical shock.
• Check with a qualified electrician if you are in doubt
as to whether the appliance is properly grounded.
Failure to follow these instructions could result in
serious injury or death.
mlJ ADVERTISSEMENT
RISQUE DE CHOC I_LECTRIQUE
• Le circuit d'alimentation du four doit
_tre hors tension pendant le
branchement.
• Utiliser uniquement des ills en
cuivre.
• Cet appareit dolt 6tre mis _ la terre. L'extr_mit_ du fit
vert (te fil de mise _ la terre) dolt 6tre branch_e
une terre apprepri_e. Ce fil dolt rester branch_ au
four,
• NE PAS utiliser pour la mise _ la terre un tuyau d'eau
freide interrompu par du plastique, des joints ou des
raccords non-m_taltiques, eu autre materiel iselant.
• NE PAS mettre _ laterre sur untuyau degaz.
• NE PAS utiliser de fusible sur le circuit de NEUTRE ou
de MISE _, LA TERRE. Un fusible dans te circuit de
NEUTRE ou de MISE _, LA TERRE peut causer un
chec _lectrique.
• En cas de doute, faire v_rifier la raise _ la terre de
I'appareil par un _lectricien quatifi&
I1faut suivre ces instructions pour _viter des btessures
graves ou la mort.
STEP 21 INSTALL JUNCTION BOX
The conduit is located in the center at the top rear of
the oven.
• Locate and install the junction box within reach of
the power cable.
• Install the junction box in an adjacent left or right
cabinet, below the cutout floor, or in the top cabinet
above the cutout.
-3/4"
lax
9