Expressbuilder For Dos-Based With Local Console - NEC Express5800 140Rd-4 User Manual

6-4

EXPRESSBUILDER for DOS-Based with Local Console

This subsection describes the procedures for using EXPRESSBUILDER for DOS-based with local console.
Starting EXPRESSBUILDER
The following procedure instructs you to start EXPRESSBUILDER.
IMPORTANT: Do not remove the EXPRESSBUILDER CD-ROM while EXPRESSBUILDER
is running.
1.
Turn on peripheral devices and the server in this order.
2.
Insert the EXPRESSBUILDER CD-ROM supplied with your server into the CD-ROM drive of your server.
3.
Ensure that the floppy disk drive is empty.
4.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the EXPRESSBUILDER. (You may also turn
off and then on again to reboot the server.)
EXPRESSBUILDER boots up displaying the top menu.
Express Setup
"Express Setup" is intended for initial setup of the server. Its automatic installation mode guides the user easily through the
process by detailing specific hardware features and providing screen prompts for software selection and configuration. The
program loads the utilities and drivers, applies RAID settings, partitions the disk, and installs the desired operating system.
If you install Windows Server 2003, after a few tasks are completed, all that remains to be done is to remove the
EXPRESSBUILDER CD-ROM and install the Windows CD-ROM, input a product ID number, and acknowledge the license
agreement.
IMPORTANT:
The Express Setup is intended for the initial setup of the server system and, therefore, the
Express Setup clears the contents of the hard disk.
When the setup is started, do not turn off the server until the setup is completed, and also
make sure not to remove the "Configuration Diskette" from the floppy disk drive until the
message that allow you to remove it appeared.