Table of Contents
Advertisement
EXPRESSBUILDER for DOS-Based with Local Console
This subsection describes the procedures for using EXPRESSBUILDER for DOS-based with local
console.
Starting EXPRESSBUILDER
The following procedure explains how to start EXPRESSBUILDER.
IMPORTANT:
EXPRESSBUILDER is running.
Turn on peripheral devices and the server in this order.
1.
Set the EXPRESSBUILDER CD-ROM supplied with your server in the CD-ROM drive of
2.
your server.
Ensure that the floppy disk drive is empty.
3.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot EXPRESSBUILDER.
4.
(You may also turn off and then on again to reboot the server.)
EXPRESSBUILDER boots up displaying the top menu.
Do not remove the EXPRESSBUILDER CD-ROM while
Installing the Operating System and Utilities 4-21
Advertisement
Table of Contents
