Table of Contents
Advertisement
Setting Power Feed
Rate
NOTICE
Feed rate is based on spindle RPM. Pay
close attention to the feed rate you have
chosen and be ready to disengage the
apron. Failure to do this may cause the
carriage to crash into the chuck.
To set and engage the power feed:
1.
2.
Change Gear Chart
31
Figure 33.
3.
Figure 34
Note: All change gears are stamped with the
number of teeth they have.
Page
Figure 33
4.
5.
6.
7.
Figure 35
8.
Figure 35
Figure 34.
Figure 35.
Figure 33
Advertisement
Table of Contents
