Cisco Telepresence MX300 Administrator's Manual page 61

Cisco TelePresence MX Series
AdministrAtor guide
Table of contents Introduction
Video AllowWebSnapshots
Allow or disallow that snapshots captured by the video input main source can be displayed in the
web interface Call Control page.
NOTE: This feature is disabled by default, and must be enabled from the Touch controller.
Requires user role: ADMIN
Value space: <On/Off>
On: If set to on, a web snapshot can be generated and displayed on the web interface.
Off: The generation of web snapshots is not allowed.
Example: Video AllowWebSnapshots: Off
Video Output LCD [1] Resolution
Set the screen resolution.
Requires user role: ADMIN
Value space: <1920_1080_60>
Range: The screen resolution is 1920 x 1080 60 Hz.
Example: Video Output LCD 1 Resolution: 1920_1080_60
Video Output LCD [1] MonitorRole
Set the LCD monitor role.
It is highly recommended to use the default setting. NOTE: The settings made here will be
overruled by the touch controller.
Requires user role: ADMIN
Value space: <First/Second/PresentationOnly/InternalSetup>
First: Show main video stream.
Second: Show presentation video stream if active, or other participants.
PresentationOnly: Show presentation video stream if active, and nothing else.
InternalSetup: Internal setup from the touch controller will be used.
Example: Video Output LCD 1 MonitorRole: InternalSetup
Video Output LCD [1] Brightness
Set the brightness level for the monitor.
Requires user role: ADMIN
Value space: <S: 0, 100>
Range: Select a value from 0 to 100.
Example: Video Output LCD 1 Brightness: 50
D14850.02 MX Series Administrator Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings Appendices
Video Output LCD [1] Red
Set the Red color level for the monitor.
Requires user role: ADMIN
Value space: <S: 0, 100>
Range: Select a value from 0 to 100.
Example: Video Output LCD 1 Red: 50
Video Output LCD [1] Green
Set the Green color level for the monitor.
Requires user role: ADMIN
Value space: <S: 0, 100>
Range: Select a value from 0 to 100.
Example: Video Output LCD 1 Green: 50
Video Output LCD [1] Blue
Set the Blue color level for the monitor.
Requires user role: ADMIN
Value space: <S: 0, 100>
Range: Select a value from 0 to 100.
Example: Video Output LCD 1 Blue: 50
Video Output Internal [2] MonitorRole
Determine the role of the internal monitor and select where to show the video stream and
presentation.
It is highly recommended to use the default setting.
Requires user role: ADMIN
Value space: <First/Second/PresentationOnly>
First: Show the main video stream.
Second: Show presentation video stream if active, or other participants.
PresentationOnly: Show presentation video stream if active, and nothing else.
Example: Video Output Internal 2: First
Video Selfview
Determine if the main video source (selfview) shall be displayed on screen.
Requires user role: USER
Value space: <On/Off>
On: Display selfview on screen.
Off: Do not display selfview on screen.
Example: Video Selfview: On
61
www.cisco.com