Uninstalling The Cisco Microsoft Windows Vista Usb Driver; Entering The Initial Configuration Information; Ip Settings - Cisco CGS 2520 Hardware Installation Manual

Entering the Initial Configuration Information

Using the Setup.exe Program
Disconnect the switch console terminal before uninstalling the driver.
Note
Step 1 Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64-bit. Click Next.
Step 2 The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 3 When the Program Maintenance window appears, select the Remove radio button. Click Next.
When the Remove the Program window appears, click Remove.
Step 4
When the InstallShield Wizard Completed window appears, click Finish.
Step 5

Uninstalling the Cisco Microsoft Windows Vista USB Driver

Disconnect the switch console terminal before uninstalling the driver.
Note
Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 1
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 2
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 3
When the Remove the Program window appears, click Remove.
Step 4
Note If a User Account Control warning appears, click Allow - I trust this program to proceed.
When the InstallShield Wizard Completed window appears, click Finish.
Step 5
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch
powers on. You must assign an IP address and other configuration information necessary for the switch
to communicate with the local routers and the Internet.

IP Settings

You need this information:
•
•
•
•
Cisco CGS 2520 Hardware Installation Guide
C-6
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Appendix C Configuring the Switch with the CLI Setup Program
OL-31444-01