The Port Forwarding Rule Edit Screen - ZyXEL Communications P-660H-61 User Manual

Table 42 Network > NAT > Port Forwarding (continued)
LABEL
Active
Service Name
Start Port
End Port
Port Translation
Start/End Port
Server IP Address
Modify
Back
Apply
Cancel

9.3.2 The Port Forwarding Rule Edit Screen

Use this screen to edit a port forwarding rule. Click the rule's edit icon in the Port Forwarding
screen to display the screen shown next.
Figure 64 Network > NAT > Port Forwarding: Edit
The following table describes the fields in this screen.
Table 43 Network > NAT > Port Forwarding: Edit
LABEL
Rule Setup
Active
Service Name
Start Port
ADSL Router Series User's Guide
DESCRIPTION
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This is a service's name.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
This is the start/end port number that the device translates.
This is the server's IP address.
Click the edit icon to go to the screen where you can edit the port forwarding rule.
Click the delete icon to delete an existing port forwarding rule. Note that subsequent
address mapping rules move up by one when you take this action.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
DESCRIPTION
Click this check box to enable the rule.
Enter a name to identify this port-forwarding rule.
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port number in
the End Port field.
Chapter 9 Network Address Translation (NAT)
155