Test The Path From Your Computer To A Remote Device - NETGEAR Nighthawk R7000 User Manual

Nighthawk AC1900 Smart WiFi Router Model R7000
Verify that the IP address for your router and your computer are correct and that the
addresses are on the same subnet.

Test the Path from Your Computer to a Remote Device

After verifying that the LAN path works correctly, test the path from your computer to a remote
device.
1. From the Windows toolbar, click the Start button and select Run.
2. In the Windows Run window, type:
ping -n 10 <IP address>
where <IP address> is the IP address of a remote device such as your ISP DNS server.
If the path is functioning correctly, messages like those shown in the previous section display.
If you do not receive replies, check the following:
• Check that your computer has the IP address of your router listed as the default gateway.
If DHCP assigns the IP configuration of your computers, this information is not visible in
your computer Network Control Panel. Verify that the IP address of the router is listed as
the default gateway.
• Check to see that the network address of your computer (the portion of the IP address
specified by the subnet mask) is different from the network address of the remote device.
• Check that your cable or DSL modem is connected and functioning.
• If your ISP assigned a host name to your computer, enter that host name as the account
name in the Internet Setup screen.
• Your ISP might be rejecting the Ethernet MAC addresses of all but one of your
computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address of
your broadband modem. Some ISPs additionally restrict access to the MAC address of a
single computer connected to that modem. If so, configure your router to "clone" or
"spoof" the MAC address from the authorized computer.
Troubleshooting
163