Using Leads To Monitor - HP Codemaster 100 User Manual

Using Leads to Monitor

5
The monitoring functions of the HP CodeMaster 100 may be performed
through any of the ECG sources shown in Table 5-1. The leads which may be
monitored are dependent upon the ECG source and whether the defibrillator
is configured to monitor a 3 or 5-wire patient cable. Once an ECG source is
determined, the Lead Select control is used to choose the desired lead to
monitor.
Table 5-1 lists ECG sources and appropriate Lead Select choices for each
source.
Table 5-1 Cardiac Monitoring Configurations
For this ECG source...
When multifunction defib electrodes are used to pace-on-demand, an
NOTE
alternate ECG source must be used for monitoring and Lead Select should
be set to the desired monitoring lead.
5-2
Using Leads to Monitor
Use this lead wire set/cable type...
1
The Lead Select choices are always I, II, III when the defibrillator is configured for
a 3-wire cable; the choices are always I, II, III, aVR, aVL, aVF, V when config-
ured for a 5-wire cable.
2
The actual V lead shown is dependent upon electrode placement.
3
V with 12-Lead only will be displayed when the V lead is selected.
1
1
Set Lead Select to...