Troubleshooting; Checkout For W7212, W7213, W7214 Economizers Connected To Honeywell Actuator; Meter Location For Checkout And Troubleshooting (W7212 Shown) - Honeywell W7212 Product Data

W7212, W7213, W7214 ECONOMIZER LOGIC MODULES
CHECKOUT AND

TROUBLESHOOTING

Checkout requires a 9V battery, 620 ohm, 1.2K ohm,
5.6K ohm, and 6.8K ohm resistors. Use Table 4 and Fig. 18 for
checkout.
CAUTION
Equipment Damage Hazard.
Excessive force can damage potentiometer
controls.
Use a small screwdriver when adjusting enthalpy
changeover and minimum damper position controls.
Table 4. Checkout for W7212, W7213, W7214 Economizers Connected to Honeywell Actuator.
Step
1. CHECKOUT PREPARATION FOR ECONOMIZING ONLY
Disconnect power at TR and TR1.
Disconnect devices at P and P1.
Jumper P to P1 (defaults to on board MIN POS potentiometer).
Place 5.6K ohm resistor across T and T1 (Blue sleeve- provides input to
economizer that the MAT is between 50-55F).
Jumper TR to 1 (call for cooling from the thermostat).
W7212 only: Jumper TR to N (places economizer in occupied mode).
If connected, remove C7400 Enthalpy Sensor from terminals S
Connect 1.2K ohm, from 4074EJM Checkout Resistor kit, (purple sleeve)
across terminals S and + (makes OA enthalpy high).
O
Place 620 ohm resistor (white sleeve) across S
enthalpy lower than OA).
Set MIN POS and DCV MAX potentiometers fully CCW.
Turn DCV setpoint potentiometer mid position (this sets the DCV ventilation
at approximately 1000 ppm).
Turn exhaust potentiometer to mid position (motor will be approximately 50%
open when the exhaust fan contacts make).
Set enthalpy potentiometer to D.
W7214 only: Jumper TR to O.
Apply power (24 Vac) to terminals TR and TR1.
63-2596—09
Checkout Procedure
and + (makes return
R
1
DC VOLTMETER
C7400
1 INSERT DC VOLTMETER BETWEEN AQ AND AQ1 FOR
CHECKOUT AND TROUBLESHOOTING.
2
JUMPER USED FOR SINGLE ENTHALPY CONTROL.
Fig. 18. Meter location for checkout and
troubleshooting (W7212 shown).
All LED are off; Exhaust Fan contacts are open.
and +.
O
20
W7212
EXH
N1
Set
N
2V 10V
EXH
P1
P
Min
Pos
T1
Open
T
DCV
Max
+
2V 10V
AQ1
DCV
AQ
DCV
Set
SO+
2V
S 10V
SO
Free
+
SR+
Cool
B C
SR
A D
2
620 OHM RESISTOR
Proper Response
M20612