Operations And Setting Procedure Example - Fujitsu 8FX Hardware Manual

CHAPTER 22 UART/SIO

22.6 Operations and Setting Procedure Example

22.6 Operations and Setting Procedure Example
The UART/SIO has a serial communication function (operation mode 0, 1).
■ Operations of UART/SIO
● Operation mode
Two operation modes are available in the UART/SIO. Clock synchronous mode (SIO) or clock
asynchronous mode (UART) can be selected (See Table 22.6-1).
Table 22.6-1 Operation Modes of UART/SIO
Operation mode
■ Setting Procedure Example
Below is an example of procedure for setting the UART/SIO.
● Initial setup
1. Set the port input. (DDR)
2. Set the interrupt level. (ILR*)
3. Set the prescaler. (PSSRn)
4. Set the baud rate. (BRSRn)
5. Select the clock. (SMC1n:CKS)
6. Set the operation mode. (SMC1n:MD)
7. Enable/disable the serial clock output. (SMC2n:SCKE)
8. Enable reception. (SMC2n:RXE = 1)
9. Enable interrupts. (SMC2n:RIE = 1)
*: For details of the interrupt level setting register (ILR), refer to "CHAPTER 5 INTERRUPTS" in this
hardware manual and "■ INTERRUPT SOURCE TABLE" in the device data sheet.
● Interrupt processing
Read receive data. (RDRn)
462
Data length
No parity
5
6
0
7
8
5
6
1
7
8
FUJITSU SEMICONDUCTOR LIMITED
MB95630H Series
Synchronization
mode
With parity
6
7
Asynchronous
8
9
-
-
Synchronous
-
-
Length of stop bit
1 bit or 2 bits
-
MN702-00009-2v0-E