Logical Head Default - Hitachi HDS725050KLA360 Specifications
3.5 inch ultra ata/133 hard disk drive, 3.5 inch serial ata hard disk drive
Hide thumbs
Also See for HDS725050KLA360:
- Install manual (2 pages) ,
- Specifications (191 pages) ,
- Datasheet (2 pages)
Table of Contents
Advertisement
Notes:
1. To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F. In the CSEL
mode the drive address is determined by AT interface signal #28 CSEL as follows:
•
When CSEL is grounded or at a low level, the drive address is 0 (Device 0).
•
When CSEL is open or at a high level, the drive address is 1 (Device 1).
2. In CSEL mode, installing or removing the jumper blocks at A-B or C-D position does not affect any selec-
tion of Device or Cable Selection mode.
3. The shipping default position is the Cable Select position.
7.1.3.2 15 logical head default
The figure below shows the jumper positions used to select Device 0, Device 1, Cable Selection, or Device1
(Slave) Present setting 15 logical heads instead of default 16 logical head models.
Notes:
1. To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F. In the CSEL
mode the drive address is determined by AT interface signal #28 CSEL as follows:
•
When CSEL is grounded or at a low level, the drive address is 0 (Device 0).
•
When CSEL is open or at a high level, the drive address is 1 (Device 1).
2. In CSEL mode, installing or removing the jumper blocks at A-B or C-D position does not affect any selec-
tion of Device or Cable Selection mode.
I
G
E
C
A
H
F
D
B
I
G
E
C
A
H
F
D
B
I
G
E
C
A
H
F
D
B
I
G
E
C
A
H
F
D
B
Deskstar 7K500 and Deskstar E7K500 Hard Disk Drive Specification
DEVICE 0
(Master)
DEVICE 1
(Slave)
CABLE SEL
DEVICE 1 (Slave) Present
48
Hide quick links:
Advertisement
Table of Contents
