7.1.2 Jumper pin assignment
There are four jumper settings as shown in the following sections:
•
16 logical head default (normal use)
•
15logical head default
•
32 GB clip
•
Power up in standby
Within each of these four jumper settings the pin assignment selects Device 0, Device 1, Cable Selection, or Device
1 Slave Present as shown in the following figures.
The Device 0 setting automatically recognizes device 1 if it is present.
The Device 1 Slave Present setting is for a slave device that does not comply with the ATA specification.
Note: In conventional terminology "Device 0" designates a Master and "Device 1" designates a Slave.
Deskstar 7K500 and Deskstar E7K500 Hard Disk Drive Specification
46