Cisco 3600 Series Installation Manual page 40

Installing and Configuring Flash Memory Cards in Cisco 3620, Cisco 3640, and Cisco 3660 Routers
Press Return or type y to erase the current contents of the partition, or enter n to save the contents. Then
Step 3
confirm your selection:
Copy 'TESTFILE' from flash: device
as 'TESTFILE' into slot0: device WITHOUT erase? [yes/no] y
!
[OK - 68/4194304 bytes]
Flash device copy took 00:00:05 [hh:mm:ss]
Verifying checksum...
Copying a Running Configuration File to a Flash Memory Card
You can also use a Flash memory card to store a backup copy of a configuration file. Follow these steps
to copy a configuration file to a Flash memory card:
Enter privileged EXEC mode:
Step 1
Router> enable
Password: <password>
Enter the copy running-config {slot0: | slot1:}[partition:filename] command. Replace partition with
Step 2
the partition number and filename with the name of the file, for example:
Router# copy running-config slot0:3:myconfig
PCMCIA Slot0 flash directory, partition 3:
File
1
[132 bytes used, 4194172 available, 4194304 total]
Building configuration...
Erase flash device before writing? [confirm] n
Note
Press Return or enter y to erase the current contents of the partition, or enter n to save the contents. Then
Step 3
confirm your selection:
Copy 'running-config'
as 'myconfig' into flash device WITHOUT erase? [yes/no] y
!
[OK - 922/4194172 bytes]
Verifying checksum...
Flash device copy took 00:00:00 [hh:mm:ss]
Cisco 3600 Series Hardware Installation Guide
5-40
OK (0x4ACD)
Length Name/status
68 TESTFILE
If you omit the partition and filename variables, you are prompted for them.
OK (0xC4D4)
Chapter 5 Installing Memory in the Router
OL-2056-02