Cisco 3600 Series Installation Manual page 4

Accessing the Mainboard
Before opening the chassis, disconnect the telephone-network cables to avoid contact
Warning
with telephone-network voltages. To see translations of the various warnings that
appear in this publication, refer to the Regulatory Compliance and Safety Information
document that accompanied this device.
Disconnect all network interface cables from the rear panel.
Step 2
Place the router on a flat surface. Remove the five screws located on top of the cover.
Step 3
Rotate the cover up to a 45-degree angle. (See
Step 4
Slide the cover to the side until the tabs are free from the slots. (See
Step 5
Figure 5-3
1 Lift cover
Cisco 3600 Series Hardware Installation Guide
5-4
Removing the Cisco 3631 Router Cover
Chapter 5
Figure 5-3.)
2
2 Slide cover
Installing Memory in the Router
Figure 5-3.)
1
OL-2056-02