Cisco 3600 Series Installation Manual page 23

Chapter 5 Installing Memory in the Router
Figure 5-17 Removing Flash Memory SIMMs
SIMM polarization notch
Installing Flash Memory SIMMs
Perform this procedure to install Flash memory SIMMs:
Step 1 Locate the Flash memory SIMM sockets on the mainboard. (See
Caution Handle SIMMs by the non-connector edges only. SIMMs are ESD-sensitive components and can be
damaged by mishandling.
Hold the SIMM with the polarization notch on the right and the component side away from you, with
Step 2
the connector edge at the bottom.
Beginning with bank 0, insert the Flash memory SIMM into its connector slot at an angle, tilted toward
Step 3
the left side of the chassis. (See
amount of force required. When the SIMM is properly seated, the socket guide posts fit in the alignment
holes, and the locking springs click into place. Use a minimum of force.
OL-2056-02
Top view
1. Pull the locking spring clips outward.
2. Push the top of the SIMM
forward and down.
Front of chassis
Figure 5-18.) Rock the SIMM into a vertical position using the minimum
Cisco 3600 Series Hardware Installation Guide
Replacing Flash Memory SIMMs
Figure 5-14 through Figure 5-16.)
5-23