Base Charge Mode - Honeywell 2020-5 User Manual

Base Charge Mode

In order for the battery to be charged, there must be enough voltage for the cir-
cuitry to work. There are three conditions during which power can be supplied
to the base:
Condition 1:9VDC power supply connected to the barrel connector
Condition 2:12VDC host power source only
Condition 3:5VDC host power source only
The chart below describes each selection by condition.
Automatic
Full Charge Rate
Low Charge Rate
Battery Charge Off
Using a slow charge rate draws less current (power) from the input power
source when the battery is mostly discharged.
Scan the appropriate bar code for your application. Default = Automatic .
* Automatic
Low Charge Rate
1 - 4
Condition 1
Fast Charge
Fast Charge
Slow Charge
No Charge
Condition 2
Slow Charge
Fast Charge
Slow Charge
No Charge
Full Charge Rate
Battery Charge Off
Condition 3
No Charge
No Charge
No Charge
No Charge