Advertisement
NTP-E150 Change the Optical Line Rate
Click OK. The row on the Pluggable Ports pane turns light blue until the actual SFP is installed and then
Step 9
the row turns white.
Stop. You have completed this procedure.
NTP-E150 Change the Optical Line Rate
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Click the Alarms tab:
Step 2
a.
b.
c.
In node view, double-click the ASAP card where you want to edit the PPM port rate.
Step 3
Click the Provisioning > Pluggable Port Modules tabs.
Step 4
Click the port with the port rate you want to change in the Pluggable Ports pane. The highlight changes
Step 5
to dark blue.
Click Edit. The Edit Port Rate dialog box appears.
Step 6
In the Change To field, use the drop-down menu to select the new port rate and click OK.
Step 7
Click Yes on the Confirm Port Rate Change dialog box.
Step 8
Stop. You have completed this procedure.
Cisco ONS 15600 Procedure Guide, R5.0
11-4
This procedure changes PPM port rates for the ASAP card. Perform this
procedure if you want to change the port rate on a multi-rate SFP that is
already provisioned.
None
NTP-E157 Provision a Multirate PPM, page 11-2
As needed
Onsite or remote
Provisioning or higher
"DLP-E26 Log into CTC" task on page 16-39
Verify that the alarm filter is not turned on. See the
page 17-50
as necessary.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.
Complete the
"DLP-E76 Export CTC Data" task on page 16-98
information.
Chapter 11
to log into an ONS 15600 on the network.
"DLP-E157 Disable Alarm Filtering" task on
to export alarm and condition
Change Card Settings
February 2008
Advertisement
