Advertisement
Chapter 11
Change Card Settings
You can repeat Steps
Step 6
Stop. You have completed this procedure.
NTP-E125 Change Card Service State
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Complete the
card service state.
Click the Inventory tab.
Step 2
Click Admin State for the card you want to change, and choose an Admin state from the drop-down list:
Step 3
IS (In-Service) or OOS,MT (Out-of-Service,Maintenance).
Click Apply.
Step 4
If an error message opens indicating that the card state cannot be changed from its current state, click
Step 5
OK.
Table 11-5
information about the enhanced state model and card state transitions, refer to the "Administrative and
Service States" appendix of the Cisco ONS 15600 Reference Manual.
Table 11-5
Admin State
IS
IS
IS
OOS,MT
February 2008
4
and
5
for any other ports on that card.
This procedure changes card service state.
None
Chapter 2, "Install Cards and Fiber-Optic Cable"
As needed
Onsite or remote
Provisioning or higher
"DLP-E26 Log into CTC" task on page 16-39
lists possible card service state transitions based on the Admin State chosen. For more
Cisco ONS 15600 Card State Transitions
Original Service State
OOS-AUMA,MT & UEQ
(Out-of-Service and Autonomous
Management,Maintenance and
Unequipped)
OOS-AUMA,MEA & MT
(Out-of-Service and Autonomous
Management,Mismatched Equipment and
Maintenance)
OOS-MA,MT
(Out-of-Service and
Management,Maintenance)
OOS-AU,MEA
(Out-of-Service and
Autonomous,Mismatched Equipment)
NTP-E125 Change Card Service State
at the node where you want to change the
Next Service State
OOS-AU,UEQ
(Out-of-Service &
Autonomous,Unequipped)
OOS-AU,MEA
(Out-of-Service and
Autonomous,Mismatched Equipment)
IS-NR
(In-Service and Normal)
OOS-AUMA,MT & UEQ
(Out-of-Service and Autonomous
Management,Maintenance and
Unequipped)
Cisco ONS 15600 Procedure Guide, R5.0
11-13
Advertisement
