D-Link DHP-601AV User Manual page 9

Section 2 - Hardware Installation
2. Plug in the other DHP-600AV adapter in the room that you want to extend your network to. The Power LED will light up.
3. Verify that the PowerLine LEDs on both adapters are lit. If they are, the adapters are connected. If not, try another wall outlet (closer to the other
PowerLine adapter).
4. To secure your network, press the Simple Connect button for two seconds on one of the adapters. The Power LED will start to blink. Then, within two
minutes, press the Simple Connect button on the other adapter for two seconds. Once the Power LEDs stop blinking, verify that the PowerLine LEDs on
both adapters are lit (as in Step 3). This indicates that your adapters are properly connected to each other.
D-Link DHP-601AV User Manual
DHP-600AV
DHP-600AV
DHP-600AV
DHP-600AV
Simple Connect Button Simple Connect Button
DHP-600AV
DHP-600AV
DHP-600AV
9