Configuring Network Settings - Cisco SPA302D User Manual

Using Your Cisco SPA302D
Configuring Phone Settings
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco SPA302D Mobility Enhanced Cordless Handset User Guide
• Date and Time
• Handset Settings
• Update Software
• Factory Reset
• Phone Info

Configuring Network Settings

You can enter or modify the network settings on your handset. These settings
indicate the method that your handset and base station use to connect to the
Internet.
You should only change this setting if advised to do so by your phone system
administrator.
From the Settings menu, choose Network Settings.
Enter the PIN code (available from your phone system administrator). By default,
there is no PIN code. Press Confirm.
Press the Right and Left arrow buttons on the navigation keypad to scroll through
the available network settings and press Confirm to change the selected setting.
You can choose from the following settings:
• DHCP (most common)—The Cisco SPA302D and the Cisco SPA232D
receive an IP address from the DHCP server on your network (typically, the
router or switch to which your hardware is connected).
• Static IP—Choose this setting if you need the Cisco SPA302D to have an
assigned IP address that does not change. Enter the IP address, subnet
mask, gateway address and DNS server addresses.
• PPPoE—Choose this setting if you have a Point-to-Point Protocol over
Ethernet connection to the Internet. Enter your username, password, and
service information for your Internet connection.
Press Confirm to save your changes.
2
27