Table of Contents
Advertisement
SATA-AHCI Ports Auto Clk Ctrl [Disabled]
When set to [Enabled], the clocks for unused SATA ports in AHCI mode will
be shut down and the system saves some power, but the hotplug function for
those ports will be unavailable Configuration options: [Disabled] [Enabled]
SATA PORT 0—5 MODE [Auto]
When set to [GEN1], the SATA ports are forced to run at the GEN1 mode.
When set to [Auto], the SATA port runs at the default mode.
Configuration options: [Auto] [GEN1]
OHCI HC (Bus 0 Dev 18 Fn 0); OHCI HC (Bus 0 Dev 18 Fn 1); EHCI HC
(Bus 0 Dev 18 Fn 2); OHCI HC (Bus 0 Dev 19 Fn 0); OHCI HC (Bus 0
Dev 19 Fn 1); EHCI HC (Bus 0 Dev 19 Fn 2); OHCI HC (Bus 0 Dev 20 Fn 5)
[Enabled]
Configuraiton options: [Disabled] [Enabled]
SR5670 Configuration
Advanced
SR5650 Configuration
PCI Express Configuration
Hyper Transport Configuration
IOMMU
VGA ROM Boot Priority
Debug Options
PCI Express Configuration
PCIE Slot 2/4/5 Features; PIKE Slot/PCIE Slot 7 Features
Gen2 High Speed Mode [Auto]
Configuration options: [Auto] [Disabled] [Software Initiated] [Advertised RC]
Link ASPM [Disabled]
Configuration options: [Disabled] [L0s] [L1] [L0s & L1] [L0s Downstream]
[L0s Downstream + L1]
Compliance Mode [Disabled]
Configuration options: [Disabled] [Enabled]
4-24
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
BIOS SETUP UTILITY
[Disabled]
[PCIE VGA Card]
PCI Express
Configuration
Select Screen
←→
Select Item
↑↓
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
Chapter 4: BIOS setup
Advertisement
Table of Contents
