Assembly (1.1T) - Horizon Fitness ELITE 1.1T User Manual

Assembly
1.1T ASSEMBLY
UNPACKING
Take caution when handling and transporting this unit. Never open box when it is on its side. Once
the banding straps have been removed, do not lift or transport this unit unless it is fully assembled
and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used.
The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled.
See owner's guide for reference. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
INJURY! Place your treadmill on a level flat surface. It is recommended that you place a protective
covering on your floor.
PARTS
• 1 Power Cord
• 1 Safety Key
• 2 Water Bottle Holders
• 1 Hardware Pack (contents listed below)
• Left and right outer Console Mast Covers
TOOLS (included)
• 5mm Allen Wrench/Phillips Screw Driver
• Flat Wrench
• 8mm Allen Wrench or 6mm Allen Wrench
Note: It is recommended that you apply grease to the threads of each bolt as you assemble your
treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and
bolts are in place and partially threaded in before completely tightening any ONE bolt.
If you have any questions, or if there are any missing parts, we will guarantee complete satisfaction.
PLEASE CALL OUR TOLL-FREE DIRECT CUSTOMER ASSISTANCE CENTER @ 1-800-244-4192
HARDWARE
A) Linkage Arm
45mm bolt
Quantity: 2
B) Console Assembly Bracket
40mm bolt
Quantity: 2
Mon.-Fri., 8 a.m.-5 p.m. CST (excluding holidays).
C) Console Assembly Bracket
13mm nylon nut
Quantity: 2
7
D) Console Mast Covers
16mm bolt
Quantity: 6