For Vigor2820Vs - Draytek VIGOR2820 series Quick Start Manual

1 . 1 . 5 F o r V i g o r 2 8
1 . 1 . 5 F o r V i g o r 2 8
LED
ACT (Activity)
USB
CSM
WCF
DSL
WAN 2
Line
Phone
QoS
LED on Connector
Phone S0 Left LED
(Orange)
Right LED
(Green)
ISDN/Phone Left LED
S0 (Orange)
Right LED
(Green)
2 0 V S
2 0 V S
Status Explanation
Blinking The router is powered on and running normally.
Off The router is powered off.
On A USB device is connected and active.
Blinking The data is transmitting.
On The profile of CSM (Content Security Management)
for IM/P2P application is enabled from Firewall >>
General Setup. (Such profile is established under
CSM menu).
On The Web Content Filter is active. (It is enabled from
Firewall >> Web Content Filter and the web content
filter profile is established under CSM menu.)
On The router is ready to access Internet through DSL link.
Blinking Slowly: The modem is ready.
Quickly: The connection is training.
On The WAN1 or WAN2 connection is ready.
Blinking It will blink while transmitting data.
On A PSTN phone call comes (in and out). However, when
the phone call is disconnected, the LED will be off
about six seconds later.
Off There is no PSTN phone call.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Blinking A phone call comes.
On The QoS function is active.
On ISDN NT (ISDN S0 intern) mode is active and an
ISDN phone adapter is connected.
Blinking ISDN NT (ISDN S0 intern) mode is active and an
ISDN phone adapter is not connected.
On A phone has been connected. If not, green LED will be
off.
Blinking An ISDN phone is off-hook or a phone call comes.
On ISDN NT (ISDN S0 intern) mode is active configured
from VoIP>>Phone Settings and an ISDN phone
adapter is connected.
Blinking ISDN NT (ISDN S0 intern) mode configured from
VoIP>>Phone Settings is active and an ISDN phone
adapter is not connected.
Off It means ISDN TE mode is active which is configured
from VoIP>>Phone Settings.
On A phone adapter with phone set has been connected
(ISDN S0 intern mode) or ISDN line has been
connected (ISDN S0 extern mode). It will be off if
there is nothing connected.
10
Vigor 2820 Series Quick Start Guide