Honeywell RAPID EYE MULTI-MEDIA Operator's Manual page 81

Table 16
Event reference, by source and tab.
Source Event in maintenance,
except where noted
outside System: no video recording*
world
Inputs: activate, input ports 1
to 16
Inputs: deactivate, input
ports 1 to 16
Video: signal unlock,
cameras 1 to 16
Video: lock
Motion: Not on Event tab; on
the Video tab.
customer- user defined: Not on Event
device tab; on Serial Devices tab.
View Session: connect, reject and
operator disconnect
Maintenance: changes to
configuration, security, time,
storage and so on...
Outputs: activate, output
ports 1 to 8
Outputs: deactivate, output
ports 1 to 8
System: no video recording*
System: reboot
Multi-Media System: failure, self-restart,
unit reboot
System: No video recording*
System: time server,
no synch, clock drift...
System: disk failure
* Some events are repeated in the table: their source can vary. For example: an alarm
triggered by an "outside world" events can also be triggered by rebooting a unit.
†
A Multi SA can set a Video lock event to be only logged rather than trigger an alarm.
‡
Some configuration settings can be changed onsite, using LocalView. These changes
are not logged nor do they trigger an alarm when the configuration event is set tot do so.
†
, cameras 1 to 16
‡
†
Alarms and Events
Cause: an alarm or log entry
could indicate ...
a cut cable, dead camera, power
outage
security sensor has been triggered or
the Multi-Media unit is booting
security sensor has been reset or the
unit is booting
cut cable, hardware failure in a Rapid
Eye Multi Multi-Media unit, faulty
camera... Can be momentary.
a buggy camera; time since video
unlock helps troubleshooting
intruder, a change in lighting, fire, an
explosion, vermin, and so on.
transaction made using hardware at a
customer's facility
use/misuse of View to connect to or
disconnect from a site. Session
rejections can also be watched
use/misuse of maintenance by an
operator or Multi SA; for example to
monitor Clear storage or Synchronize
time by operator of View
use/misuse of an onsite device by a
View operator ex.: locking a gate at a
site, by remote control
use/misuse of an onsite device by a
View operator
ex.: unlocking a gate at a site, by
remote control
camera disabled by View operator
use/misuse of Reboot command by
operator
power failure or catastrophic failure of
unit
failure of unit's video hardware
failure of network or network's time
server
warning of imminent failure of storage
6–17