Advertisement
Overload protector
The overload protector automatically cuts
out to break the circuit and the button
pops out, whenever heavy work is pro-
longed. When this occurs, release the trigger
switch and withdraw the tool from the
workpiece. Wait 20 - 30 seconds before
pressing the restart button to resume
operation.
4.8 (3/16")
CAUTION
:
Your finger should not be on the trigger when you press the restart button.
3.1
-
3.4
(1
/8" - 9/64")
Screwdriving operation
Place the point
of
the driver bit in the
screw head and apply pressure to the tool.
Start the tool slowly and then increase the
speed gradually. Release the trigger just as
the screw bottoms out. The electric brake
will then stop the tool immediately, pre-
venting the screw and/or bit from being
damaged.
NOTE
:
*Make sure that the driver bit is inserted straight in the screw head, or the screw and/or
bit may be damaged.
When driving wood screws, predrill Pilot
holes to make driving easier and to pre-
3.1 (1/8")
3.5 (9/64")
(3/32" - 3/32")
vent splitting of the workpiece. See the
chart.
4.5 (11/64")
(7/64"
-
1/8")
5.5 (7/32")
5.8 (I-'"'''
9
Advertisement
