Additional Safety Rules - Makita 3612BR Instruction Manual

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified
on
the
nameplate of the tool. A power source w i t h voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user
-
as well as damage t o
the tool. If in doubt,
DO
NOT PLUG IN THE
TOOL.
Using a power source w i t h
voltage less than the nameplate rating
is
harmful t o the motor.
ADDITIONAL SAFETY RULES
1.
Handle the bits very carefully.
2.
Check the bit carefully for cracks or damage before operation. Replace
3. Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
4.
Hold the tool firmly w i t h both hands.
5. Keep hands away from rotating parts.
6.
Make sure the bit is not contacting the workpiece before the switch is turned
7.
Before using the tool on an actual workpiece, let it run for a while. Watch
8.
Be careful of the
bit
rotating direction and the feed direction.
9. Do
not leave the tool running. Operate the tool only when hand-held.
cracked or damaged bit immediately.
fore operation.
on.
for vibration or wobbling that could indicate improperly installed bit.
I O .
Always switch off and wait for the bit t o come t o a complete stop before
1 1 .
Do not touch the bit immediately after operation;
it
may be extremely hot
removing the tool from workpiece.
and could burn your skin.
SAVE THESE INSTRUCTIONS.
4